Ribbon Driver: The ribbon tweeter driver is a very thin corrugated aluminum 'voice coil' hanging freely like a streamer in a side-by-side magnetic field. A ribbon is actually a type of dynamic driver, in which the voice coil is in the form of a flat, ribbon-shaped conductor which, positioned between opposite magnetic fields, actually becomes the diaphragm itself. The ribbon is free of the stretched film resonance's and obstructing magnets of the planar-magnetic, so it offers outstanding pulse response, uniform drive, and a good approximation of a line source, but the efficiency and impedance are both phenomenally low and the base technology is not usable as a woofer due to the small area. Most practical ribbons either use a step-down transformer or ask the amplifier to drive a ½ ohm load (not a practical solution for most). The ribbon cannot be used to produce low frequencies. To create a moving element large enough to generate frequencies lower than a few hundred Hertz would mean moving opposing magnetic poles so far apart that they no longer exert a sufficient magnetic field over the entire area of the ribbon. But, a ribbon offers very precise treble around, superior to dynamics or electrostatics. In many ways, a ribbon driver can be an excellent performer: the moving element (the ribbon itself) is extremely light, allowing good speed and transient performance as well as freedom from coloration. They are however, expensive, and hard to find.

 

Related Words

Ribbon Driver: The ribbon tweeter driver is a very thin corrugated aluminum 'voice coil' hanging freely like a streamer in a side-by-side magnetic field. A ribbon is actually a type of dynamic driver, in w . . . View Full Definition

Ribbon (Girt): Normally a 1 X 4 board let into the studs horizontally to support the ceiling or second-floor joists.

Ribbon Cable: A flat cable with wires that run in parallel to each other, like those used for IDE or SCSI.

Piezoelectric Driver: This is among the most robust and least expensive alternative drivers for the high frequency reproduction. The material used in the Piezoelectric Driver is a piezoelectric polymer first deve . . . View Full Definition